   Bindings for specific devices:

      i) Xilinx ML300 Framebuffer

      Simple framebuffer device from the ML300 reference design (also on the
      ML403 reference design as well as others).

      Optional properties:
       - resolution = <xres yres> : pixel resolution of framebuffer.  Some
                                    implementations use a different resolution.
                                    Default is <d#640 d#480>
       - virt-resolution = <xvirt yvirt> : Size of framebuffer in memory.
                                           Default is <d#1024 d#480>.
       - rotate-display (empty) : rotate display 180 degrees.

      v) Xilinx hwicap

		Xilinx hwicap devices provide access to the configuration logic
		of the FPGA through the Internal Configuration Access Port
		(ICAP).  The ICAP enables partial reconfiguration of the FPGA,
		readback of the configuration information, and some control over
		'warm boots' of the FPGA fabric.

		Required properties:
		- xlnx,family : The family of the FPGA, necessary since the
                      capabilities of the underlying ICAP hardware
                      differ between different families.  May be
                      'virtex2p', 'virtex4', or 'virtex5'.
		- compatible : should contain "xlnx,xps-hwicap-1.00.a" or
				"xlnx,opb-hwicap-1.00.b".

      vii) Xilinx USB Host controller

      The Xilinx USB host controller is EHCI compatible but with a different
      base address for the EHCI registers, and it is always a big-endian
      USB Host controller. The hardware can be configured as high speed only,
      or high speed/full speed hybrid.

      Required properties:
      - xlnx,support-usb-fs: A value 0 means the core is built as high speed
                             only. A value 1 means the core also supports
                             full speed devices.

